What is MRMC's Target Tracking and how to use it¶
Playlists: Flair 7 Training Videos, Cinebot Mini/Max & Flair 7 Training
Related HOW TO: Estimate Target
Searchable transcript: Open full transcript
AI Summary
A video explaining MRMC's Target Tracking and how to use it.
For operators using this as a reference, the main focus is CGI matching, Maya workflows, motion smoothing, move programming, and target tracking, while it also touches on track calibration. It should help when deciding which Flair workflow, robot behaviour, or setup area is relevant before opening the full video.
The practical setup context is that hardware referenced includes CAMERA_RED and PRECISION_TRACK. This helps connect the video to the rig, accessory, software environment, or workflow label an operator may already be working with.
The chapter links below provide 11 timestamped jumps into the main setup, demonstration, and workflow moments, making it easier to go straight to the section that matches the issue or task being investigated.
Chapters
- 00:10 — something about uh what we call Target tracking Target tracking was developed
- 00:57 — nowadays in 3D uh uh programs and CGI
- 02:06 — and free Drive good so I have a simple two-point move if I look at it
- 02:58 — obvious uh so I'm going to adjust my move even further
- 05:08 — cm okay so what I do uh I'm at the end of my move so I'm going to type here
- 06:17 — have seen that my focus didn't adjust to my focus uh earlier when I ran the move
- 08:11 — roll is set to relative which it can't do when it's not in Target tracking so
- 08:57 — two target positions because each key frame or Waypoint has its own Target
- 10:29 — created a key frame yet I'm going to create now so add a new Waypoint way
- 11:17 — accelerating and this is effectively by this is 49% too fast or over
- 12:23 — okay so with regards to Target tracking you can always measure with a